Hydraulic motor when heavy, need to pay attention to the following points:
1, at the time of removal of the motor, to dismantle the tubing, and position of oil on the oil pump and tubing to interface sealed immediately, to ensure that no dust and so on into the pipe after the meeting;
2, install the motor, must be "stable", rather than a "quick";
3, after waiting for tubing all installed, will in the motor of air discharge;
4, after the installation, to motor adding suitable amount of new clean the hydraulic oil;
5, check the oil motor, idle speed idling about ten minutes, see if any oil leakage phenomenon;
6, slow operation lever in one direction makes mixing drum at a slower feed direction 20 minutes;
7, the joystick back in the middle of the position, after mixing stop will be the use of oil filling can be back to normal.
Above is the matters needing attention about heavy hydraulic motor, the content is provided by hengtong hydraulic co., LTD., ningbo hengtong hydraulic co., LTD., specializing in the production of hydraulic motor, the country ordering website: www.helmtower.com