Cycloid hydraulic motor, in the case of daily use in the oil, what are we to do? First we should grab the reason, the cause of the motor oil in general there are three:
Shaft end leakage: due to motor oil seal with the output shaft in the daily time using constant friction conditions, bound to lead to oil seal and shaft interface of wear and tear, beyond a certain limit will lose oil seal, seal leak.. The solution: need to change oil seal, if the output shaft wear needs to change the output shaft at the same time.
2. Block leaks: block the following "O" type ring crush or aging and loss of sealing effect, the situation is very low probability of occurrence, if there is a need to change the "O" type circle.
3. Caught between the motor oil: located in the motor shell and plate of the side, or with the daughter of the side plate, or the daughter and the "O" type circle between the back plate aging or crush, if it happens to just change the "O" type circle.
That's what will appear cycloid hydraulic motor oil should be how to deal with.